Configuring Options Related To Dial Plan - 3Com MSR 50 Series Configuration Manual

2270 C 132: V
HAPTER OICE
Configuring Options
Related to Dial Plan
E C
NTITY ONFIGURATION
transmitted only when an active voice segment is detected. Researches show that
VAD can save the transmission bandwidth by 50%.
Follow these steps to enable VAD:
To do...
Enter system view
Enter voice view
Enter voice dial program view dial-program
Create a POTS entity and
enter POTS entity view
Enable VAD
Follow these steps to configure options related to the dial plan:
To do...
Enter system view
Enter voice view
Enter voice dial program view dial-program
Create a POTS entity and
enter POTS entity view
Configure the calling number
permitted to originate calls to
the local voice entity
Configure the priority of the
POTS entity
Configure a dial prefix
Configure the number
sending mode
For details about the above commands, refer to
page 2289.
Use the command...
system-view
voice-setup
entity entity-number pots
vad-on
Use the command...
system-view
voice-setup
entity entity-number pots
caller-permit calling-string
priority priority-order
dial-prefix string
send-number { digit-number
| all | truncate }
"Dial Plan Configuration" on
Remarks
-
-
-
-
Required
By default, VAD is disabled.
Note that G.711 codec does
not support VAD.
Remarks
-
-
-
-
Optional
By default, no calling number
is configured, that is,
incoming calls are not
restricted.
Optional
0 by default. The bigger the
value is, the lower the priority
is.
Optional
By default, no dial prefix is
configured.
Optional
By default, the truncate
mode is used, that is,
numbers matching the
wildcard "." at the end will be
sent.