Specifying The Hwtacacs Accounting Servers - 3Com MSR 50 Series Configuration Manual

1778 C 93: AAA/RADIUS/HWTACACS C
HAPTER
n
Specifying the
HWTACACS Accounting
Servers
n
ONFIGURATION
To do...
Create a HWTACACS scheme
and enter HWTACACS
scheme view
Configure the IP address and
port of the primary
HWTACACS authorization
server
Configure the IP address and
port of the secondary
HWTACACS authorization
server
The IP addresses of the primary and secondary authorization servers cannot be
■
the same. Otherwise, the configuration fails.
You can remove an authorization server only when no active TCP connection
■
for sending authorization packets is using it.
Follow these steps to specify the HWTACACS accounting servers and perform
related configurations:
To do...
Enter system view
Create a HWTACACS scheme
and enter HWTACACS
scheme view
Configure the IP address and
port of the primary
HWTACACS accounting
server
Configure the IP address and
port of the secondary
HWTACACS accounting
server
Enable the device to buffer
stop-accounting requests
getting no responses
Set the maximum number of
stop-accounting request
transmission attempts
The IP addresses of the primary and secondary accounting servers cannot be
■
the same. Otherwise, the configuration fails.
You can remove an accounting server only when no active TCP connection for
■
sending accounting packets is using it.
Currently, HWTACACS does not support keeping accounts on FTP users.
■
Use the command...
hwtacacs scheme
hwtacacs-scheme-name
primary authorization
ip-address [ port-number ]
secondary authorization
ip-address [ port-number ]
Use the command...
system-view
hwtacacs scheme
hwtacacs-scheme-name
primary accounting
ip-address [ port-number ]
secondary accounting
ip-address [ port-number ]
stop-accounting-buffer
enable
retry stop-accounting
retry-times
Remarks
Required
By default, no HWTACACS
scheme is created.
Required
The defaults are as follows:
0.0.0.0 for the IP address, and
49 for the TCP port.
Required
The defaults are as follows:
0.0.0.0 for the IP address, and
49 for the TCP port.
Remarks
-
Required
By default, no HWTACACS
scheme is created.
Required
The defaults are as follows:
0.0.0.0 for the IP address, and
49 for the TCP port.
Required
The defaults are as follows:
0.0.0.0 for the IP address, and
49 for the TCP port.
Optional
Enabled by default
Optional
100 by default