Displaying And Maintaining Tp/Ts/Rate Limiting - 3Com MSR 50 Series Configuration Manual

1638 C 84: T
HAPTER RAFFIC
Displaying and
Maintaining
TP/TS/Rate Limiting
C , P ,
LASSIFICATION OLICING AND
To do...
Configure layer 2 interface
module LR
Enter port group view
Configure port group LR
Display LR configuration and
statistics on interface
Configuration example for Line Rate on physical interface
Configure outbound line rate on interface Ethernet1/0 to 500 kbps.
# Enter system view.
<Sysname> system-view
# Enter interface view
[Sysname] interface ethernet1/0
# Configure line rate parameter, and configure the outbound cir to 500 kbps.
[Sysname-Ethernet1/0] qos lr outbound cir 500
To do...
Display TP rules
Display TP information on an interface display qos car interface
Display the TS information on a
interface
Display rate limiting configuration on
an interface and the related statistics
information
S
HAPING
Use the command...
qos lr { inbound
|outbound } cir
committed-information-rate
[ cbs committed-burst-size
[ ebs excess-burst-size ] ]
port-group aggregation
agg-id
qos lr { inbound
|outbound } cir
committed-information-rate
[ cbs committed-burst-size
[ ebs excess-burst-size ] ]
display qos lr interface
[ interface-type
interface-number ]
Command
display qos carl [ carl-index ]
[ interface-type interface-number ]
display qos gts interface
[ interface-type interface-number ]
display qos lr interface
[ interface-type interface-number ]
Remarks
Required
For a device which cannot be
installed with an external
interface module, or when
the number of the interfaces
on a layer 2 module is 4 or 9,
inbound, cbs and ebs are
not supported; if the number
of interfaces on a layer 2
module is 16, 24, or 48, ebs
is not supported on the
module and cbs defaults to
4096 bytes.
-
Required
Port group is supported if the
number of interfaces on a
layer 2 module is 16, 24 or
48.
The default value is the same
as that of the layer 2 interface
module.
The display command can be
executed in any view.
Remarks
Available in
any view