Deleting The Packed Files Of Existing Nc Software - HEIDENHAIN iTNC 530 Technical Manual

Hide thumbs Also See for iTNC 530:

Table of Contents

Deleting the packed

files of existing NC

February 2002

While in the Programming and Editing operating mode, press the MOD key.

Enter the code number 95148 and confirm your entry with the ENT key.

While in the Machine-parameter programming mode, press the MOD key.

Press the UPDATE DATA soft key.

Press the NCVer soft key.

All NC software versions that exist in the control are shown in the following

options display.

Select the NC software to be deleted with the arrow keys and press the

DELETE soft key to delete all packed NC software files. The currently active

NC software is marked with an asterisk "*" in the Sel column. Confirm your

selection with the YES soft key. With the NO soft key or the END soft key,

you exit the list box without deleting an NC software.

If the packed files of an NC software, including the currently active

software, are deleted, the respective software cannot be activated via the

list box any longer. The software concerned must then again be transferred

to the control

(See "Procedure for exchanging the NC software" on page 2 – 29).

The deletion of the packed files of the currently active NC software has no

other effects.