The Pocket Table Tool_P .Tch - HEIDENHAIN TNC 620 User Manual

The pocket table TOOL_P .TCH

The function of the pocket table depends on the
machine. Refer to your machine manual.
In the pocket table TOOL_P .TCH (permanently saved under
TNC:\table\) you specify which tools your tool magazine contains.
To enter data in the pocket table TOOL_P .TCH, proceed as follows:
Display the tool table: The TNC shows the tool
table
Display the pocket table: The TNC shows the
pocket table
Edit the pocket table: Set the EDIT soft key to ON
With the upward or downward arrow keys you can
select the pocket number that you want to edit
With the rightward or leftward arrow keys you can
select the data that you want to edit
To leave the pocket table, press the END key
Further information on this topic
Operating modes of the TNC
Further Information:
Working with the pocket table
Further Information:
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Modes of operation, page 77
Pocket table for tool changer, page 184
Setting up tools
1
1.5
69