Nortel DMS-100 Series Replacement Procedures page 509

where
volume_name
is the name of the volume that contains the PM load files, obtained in
step 64.
68 Leave the disk utility by typing
>QUIT
and pressing the Enter key.
69 Load the LCM unit by typing
>LOADPM
and pressing the Enter key.
If loadpm
passed
failed
70 Return the ESA processor to service by typing
>RTS
and pressing the Enter key.
If RTS
passed
failed
71 Send any faulty cards for repair according to local procedure.
72 Record the following items in office records:
• date the card was replaced
• serial number of the card
• symptoms that prompted replacement of the card.
73 Go to step 76.
74 Return to the procedure that directed you to this card replacement procedure.
If necessary, go to the point where the faulty card list was produced, identify
the next faulty card on the list, and go to the appropriate replacement
procedure in this manual for that card.
75 Obtain further assistance in replacing this card by contacting personnel
responsible for higher level of support.
76 You have successfully completed this procedure. Return to the maintenance
procedure that directed you to this card replacement procedure and continue
as directed.
DMS-100 Family NA100 Card Replacement Procedures Volume 4 of 7 LET0015 and up
XPM card replacement procedures
in an RLCM HIE
Do
step 70
step 75
Do
step 71
step 75
1-477
NT2X70
(end)