Nortel DMS-100 Series Replacement Procedures page 552

1-520 XPM card replacement procedures
NT2X70
in an SMS-R
(continued)
6
7
At the frame
8
At the MAP terminal
9
297-8021-547 Standard 14.02 May 2001
and pressing the Enter key.
The system determines the type of SWACT it can perform and displays a
confirmation prompt for the selected SWACT.
If SWACT
can continue at this time
cannot continue at this time
Switch the activity of the unit by typing
>YES
and pressing the Enter key.
The system runs a pre-SWACT audit to determine the ability of the inactive
unit to accept activity reliably.
Note: A maintenance flag appears when maintenance tasks are in
progress. Wait until the flag disappears before proceeding with the next
maintenance action.
If the message is
SwAct passed
SwAct failed
SwAct failed
XPM SwActback
SwAct refused by SwAct
controller
Return to the alarm clearing procedure to clear the alarm condition on the
inactive unit. When the alarm is cleared, return to step 1 of this procedure.
Hang a sign on the active unit bearing the words: "Active unit-Do not touch."
This sign should not be attached by magnets or tape.
Busy the inactive PM unit by typing
>bsy UNIT unit_no
and pressing the Enter key.
where
unit_no
is the number of the faulty SMS-R unit
Do
step 6
step 28
Do
step 8
step 7
step 7
Reason:
step 7