07/11/02 09:15:20 61TA0000_110_0310
VTEC/VTC
DTC Troubleshooting (cont'd)
11. Check for continuity between ECM/PCM connector
terminal B35 and rocker arm oil control solenoid 2P
connector terminal No. 2.
*03
ROCKER ARM OIL CONTROL SOLENOID 2P CONNECTOR
Is there continuity?
YES
NO
−
PCM (B35) and the rocker arm oil control solenoid,
then go to step 13.
12. Replace the rocker arm oil control valve (see page
11-327).
13. Reconnect all connectors.
14. Turn the ignition switch to ON (II).
15. Reset the ECM/PCM with the HDS.
16. Do the ECM/PCM idle learn procedure (see page
11-343).
17. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P2649 indicated?
YES
terminals at the rocker arm oil control solenoid and
the ECM/PCM, then go to step 1.
NO
−
11-310
VTS (GRN/YEL)
Wire side of female terminals
ECM/PCM CONNECTOR B (49P)
VTS (GRN/YEL)
Terminal side of female terminals
−
Go to step 19.
Repair open in the wire between the ECM/
−
Check for poor connections or loose
Go to step 18.
18. Monitor the OBD STATUS for DTC P2649 in the
DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES
−
Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 17,
go to the indicated DTC's troubleshooting.
−
NO
If the screen indicates FAILED, check for poor
connections or loose terminals at the rocker arm oil
control solenoid and the ECM/PCM, then go to step
1. If the screen indicates NOT COMPLETED, keep
idling until a result comes on.