Subaru Legacy 2005 Service Manual page 1805

Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step
1 CHECK HARNESS BETWEEN ECM AND OIL
SWITCHING SOLENOID VALVE.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from ECM and oil
switching solenoid valve.
3) Measure the resistance between oil switch-
ing solenoid valve and engine ground.
Connector & terminal
(E70) No. 1 — Engine ground:
(E70) No. 2 — Engine ground:
2 CHECK OIL SWITCHING SOLENOID VALVE.
1) Remove the oil switching solenoid valve
connector.
2) Measure the resistance between oil switch-
ing solenoid valve terminals.
Terminal
No. 1 — No. 2:
Check
Is the resistance more than 1
MΩ?
Is the resistance 6 — 12 Ω
EN(H6DO)(diag)-109
ENGINE (DIAGNOSTICS)
Yes
Go to step 2. Repair the short
circuit between
ECM and oil
switching solenoid
valve connector.
Repair the poor Replace the oil
contact in ECM switching solenoid
and oil switching valve. <Ref. to
solenoid valve. ME(H6DO)-80, Oil
Switching Sole-
noid Valve.>
No