Subaru Legacy 2005 Service Manual page 1520

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
5. Canister
A: REMOVAL
1) Lift-up the vehicle.
2) Remove the rear wheel LH.
3) Remove the mud guard LH.
4) Remove the protector. (Sedan model)
5) Disconnect the quick connector (A).
6) Remove the canister (B) from body.
(B)
Canister
(A)
(B)
EC-02027
EC(H6DO)-6
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Make sure there are no damage or dust on the con-
nection of quick connector. If necessary, clean the
seal surface of pipe.
Tightening torque:
⋅
8.3 N m (0.85 kgf-m, 6.1 ft-lb)
(B)
C: INSPECTION
Make sure the canister and canister hoses are not
cracked or loose.
(A)
(B)
EC-02027