Subaru Legacy 2005 Service Manual page 1722

ENGINE (DIAGNOSTICS)
9. Subaru Select Monitor
A: OPERATION
1. HOW TO USE SUBARU SELECT MONI-
TOR
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H6DO)(diag)-7, PREPARATION TOOL, Gen-
eral Description.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge to Subaru Select Monitor.
<Ref. to EN(H6DO)(diag)-7,
TOOL, General Description.>
4) Connect the Subaru Select Monitor to data link
connector.
(1) Data link connector is located in the lower
portion of instrument panel (on the driver's side).
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect any scan tools except Subaru
Select Monitor or general scan tool.
Subaru Select Monitor
5) Turn the ignition switch to ON (engine OFF), and
the Subaru Select Monitor power switch to ON.
6) Using the Subaru Select Monitor, call up DTC
and data, then record them.
2. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE (NORMAL MODE)
EN-00038
Refer to "Read Diagnostic Trouble Code (DTC)" for
information about how to indicate DTC. <Ref. to
EN(H6DO)(diag)-33, Read Diagnostic Trouble
PREPARATION
Code (DTC).>
3. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE (OBD MODE)
Refer to "Read Diagnostic Trouble Code (DTC)" for
information about how to indicate DTC. <Ref. to
EN(H6DO)(diag)-33, Read Diagnostic Trouble
Code (DTC).>
EN-00039
EN-02533
EN(H6DO)(diag)-26
(A) Power switch
(A)
EN-00040