Table of Contents
Advertisement
B: INSTALLATION
1) After setting the cylinder block to ST, install the
crankshaft bearing.
ST 18232AA000 ENGINE STAND
NOTE:
Remove oil on the mating surface of bearing and
cylinder block before installation. Apply a coat of
engine oil to crankshaft pins.
2) Position the crankshaft and connecting rod on
the #2, #4 and #6 cylinder block.
3) Apply liquid gasket to the mating surface of #1,
#3 and #5 cylinder block, and position it on #2, #4
and #6 cylinder block.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007)
NOTE:
Do not allow liquid gasket to run over to O-ring
grooves, oil passages, bearing grooves, etc.
Applying liquid gasket diameter:
±
±
1.0
0.2 mm (0.039
4) Apply a coat of engine oil to washers and bolt
threads.
5) Tighten all bolts in the numerical order as shown
in the figure.
Tightening torque:
(1) — (11), (13): 25 N
⋅
(12), (14): 20 N
m (2.0 kgf-m, 14 ft-lb)
(14)
(8)
(6)
(12)
(10)
(4)
Cylinder Block
0.008 in)
ME-00567
⋅
m (2.5 kgf-m, 18.4 ft-lb)
(1)
(3)
(9)
(11)
(13)
(2)
(5)
(7)
ME-00568
ME(H6DO)-67
6) Retighten all bolts in the numerical order as
shown in the figure.
Tightening torque:
(1) — (11), (13): 25 N
⋅
(12), (14): 20 N
m (2.0 kgf-m, 14 ft-lb)
(14)
(8)
(6)
(12)
(10)
(4)
7) Tighten all bolts 90 — 110° in the numerical or-
der as shown in the figure.
(14)
(8)
(6)
(12)
(4)
(10)
8) Install the upper bolt to cylinder block.
Tightening torque:
⋅
25 N
m (2.5 kgf-m, 18.4 ft-lb)
NOTE:
Remove the liquid gasket which is running over to
sealing surface between cylinder block and rear
chain cover, cylinder block and oil pan upper, after
tightening the bolts which combine the cylinder
block.
9) Install the rear oil seal using ST1 and ST2.
ST1 499597100
CRANKSHAFT OIL SEAL
GUIDE
ST2 499587200
CRANKSHAFT OIL SEAL IN-
STALLER
MECHANICAL
⋅
m (2.5 kgf-m, 18.4 ft-lb)
(1)
(3)
(9)
(11)
(13)
(2)
(5)
(7)
ME-00568
(1)
(3)
(9)
(11)
(13)
(2)
(5)
(7)
ME-00568
ME-00569
Advertisement
Chapters
Table of Contents
