Subaru Legacy 2005 Service Manual page 1775

Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step
1 CHECK HARNESS BETWEEN ECM AND
FRONT OXYGEN (A/F) SENSOR CONNEC-
TOR.
1) Start and warm-up the engine.
2) Turn the ignition switch to OFF.
3) Disconnect the connectors from ECM and
front oxygen (A/F) sensor.
4) Measure the resistance of harness
between ECM and front oxygen (A/F) sensor
connector.
Connector & terminal
(B134) No. 2 — (E47) No. 1:
(B134) No. 3 — (E47) No. 1:
2 CHECK HARNESS BETWEEN ECM AND
FRONT OXYGEN (A/F) SENSOR CONNEC-
TOR.
Measure the resistance of harness between
ECM and front oxygen (A/F) sensor connector.
Connector & terminal
(B134) No. 26 — (E47) No. 4:
(B134) No. 33 — (E47) No. 3:
3 CHECK HARNESS BETWEEN MAIN RELAY
AND FRONT OXYGEN (A/F) SENSOR CON-
NECTOR.
Measure the resistance of harness between
main relay and front oxygen (A/F) sensor con-
nector.
Connector & terminal
(B47) No. 3 — (E47) No. 2:
4 CHECK FRONT OXYGEN (A/F) SENSOR.
Measure the resistance between front oxygen
(A/F) sensor connector terminals.
Terminal
No. 2 — No. 1:
5 CHECK POOR CONTACT.
Check poor contact in ECM and front oxygen
(A/F) sensor connector.
Check
Is the resistance less than 1
Ω?
Is the resistance less than 1
Ω?
Is the resistance less than 1
Ω?
Is the resistance less than 5
Ω?
Is there poor contact in ECM or
front oxygen (A/F) sensor con-
nector?
EN(H6DO)(diag)-79
ENGINE (DIAGNOSTICS)
Yes
Go to step 2. Repair the open
circuit of harness
between ECM and
front oxygen (A/F)
sensor connector.
Go to step 3. Repair the open
circuit of harness
between ECM and
front oxygen (A/F)
sensor connector.
Go to step 4. Repair the open
circuit of harness
between main
relay and front
oxygen (A/F) sen-
sor connector.
Go to step 5. Replace the front
oxygen (A/F) sen-
sor. <Ref. to
FU(H6DO)-30,
Front Oxygen (A/
F) Sensor.>
Repair the poor Replace the front
contact in ECM or oxygen (A/F) sen-
front oxygen (A/F) sor. <Ref. to
sensor connector. FU(H6DO)-30,
Front Oxygen (A/
F) Sensor.>
No