Table of Contents
Advertisement
LUBRICATION
8. Engine Oil Filter
A: REMOVAL
1) Lift-up the vehicle.
2) Drain the engine oil by removing engine oil drain
plug.
3) Remove the under cover.
4) Remove the oil filter using ST.
ST 4985447000
OIL FILTER WRENCH
B: INSTALLATION
1) Clean the oil filter installing surface of oil cooler.
2) Obtain a new oil filter and apply a thin coat of en-
gine oil to the seal rubber.
3) Install the oil filter turning it by hand, being care-
ful not to damage the seal rubber.
4) Tighten further (approx. 3/4 turn) after the seal
rubber contacts oil cooler. Do not tighten exces-
sively, or oil may leak.
5) Install the under cover.
6) Lower the vehicle.
7) Fill engine oil. <Ref. to LU(H6DO)-7, INSPEC-
TION, Engine Oil.>
C: INSPECTION
1) After installing the oil filter, run engine and make
sure that no oil is leaking around the seal rubber.
NOTE:
The filter element and filter case are permanently
jointed; therefore, interior cleaning is not neces-
sary.
2) Check the engine oil level. <Ref. to LU(H6DO)-
7, INSPECTION, Engine Oil.>
Engine Oil Filter
LU-02011
LU-02035
LU(H6DO)-14
Advertisement
Chapters
Table of Contents
