Table of Contents
Advertisement
7. Knock Sensor
A: REMOVAL
1) Remove the collector cover.
2) Disconnect the ground cable from battery.
3) Remove the intake manifold.
<Ref. to FU(H6DO)-12, REMOVAL, Intake Mani-
fold.>
4) Disconnect the knock sensor connector.
5) Remove the knock sensor from cylinder block.
B: INSTALLATION
1) Install the knock sensor to cylinder block.
Tightening torque:
⋅
25 N
m (2.5 kgf-m, 18 ft-lb)
NOTE:
For the knock sensor's installation angle, refer to
the figure below.
10˚
30˚
(A) Forward
2) Connect the knock sensor connector.
Knock Sensor
IN-00203
FU-00577
45˚
(A)
FU-00578
FU(H6DO)-21
FUEL INJECTION (FUEL SYSTEMS)
3) Install the intake manifold. <Ref. to FU(H6DO)-
13, INSTALLATION, Intake Manifold.>
4) Connect the ground cable to battery.
5) Install the collector cover.
IN-00203
Advertisement
Chapters
Table of Contents
