Subaru Legacy 2005 Service Manual page 1578

MECHANICAL
13.Crank Pulley
A: REMOVAL
1) Remove the crank pulley cover.
2) Remove the crank pulley bolt. To lock the crank-
shaft, use the ST.
ST 499977100 CRANK PULLEY WRENCH
ST
3) Remove the crank pulley.
B: INSTALLATION
1) Install the crank pulley.
2) Install the crank pulley bolt. To lock the crank-
shaft, use the ST.
ST 499977100 CRANK PULLEY WRENCH
(1) Clean the crank pulley thread using com-
pressed air.
(2) Apply engine oil to the crank pulley bolt seat
and thread.
(3) Tighten the crank pulley bolts.
Tightening torque:
⋅
178 N m (18.1 kgf-m, 131 ft-lb)
ST
Crank Pulley
3) Install the crank pulley cover.
NOTE:
Assemble the O-ring to crank pulley cover.
Tightening torque:
6.4 N
ME-02028
C: INSPECTION
1) Check the crank pulley cover for oil and air leak-
age.
2) Check the crank pulley for looseness.
ME-02598
ME-02598
ME(H6DO)-44
⋅
m (0.65 kgf-m, 4.7 ft-lb)
ME-02028