Subaru Legacy 2005 Service Manual page 1476

FUEL INJECTION (FUEL SYSTEMS)
6. Camshaft Position Sensor
A: REMOVAL
1) Remove the collector cover.
2) Disconnect the ground cable from battery.
3) Remove the generator harness from fuel pipe
protector LH.
4) Remove the fuel pipe protector LH.
5) Disconnect the connector from camshaft posi-
tion sensor LH.
6) Remove the camshaft position sensor LH.
Camshaft Position Sensor
7) Remove the camshaft position sensor RH in the
same procedure as LH.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
IN-00203
FU-02117
FU-02129
FU-02130
FU(H6DO)-20
Camshaft position sensor
⋅
6.4 N m (0.65 kgf-m, 4.7 ft-lb)
Fuel pipe protector
⋅
19 N m (1.9 kgf-m, 14 ft-lb)