Subaru Legacy 2005 Service Manual page 1472

FUEL INJECTION (FUEL SYSTEMS)
6) Remove the purge control solenoid valve. <Ref.
to EC(H6DO)-7, REMOVAL, Purge Control Sole-
noid Valve.>
7) Loosen the clamp which holds fuel injector pipe
to fuel hose, and then disconnect the pipe from fuel
hose.
8) Remove the bolt which installs fuel pipes on in-
take manifold.
Intake Manifold
D: ASSEMBLY
NOTE:
When assembling the nipple, apply liquid gasket.
Liquid gasket:
THREE BOND 1105 (Part No. 004403010)
Tightening torque:
17 N
1) Tighten the bolt which installs fuel pipes on in-
take manifold.
Tightening torque:
5 N
FU-02124
FU-02125
2) Connect the fuel injector pipe to fuel hose, and
tighten the clamp screw.
Tightening torque:
1.25 N
FU-02126
3) Install the purge control solenoid valve. <Ref. to
EC(H6DO)-7, INSTALLATION, Purge Control So-
lenoid Valve.>
FU(H6DO)-16
⋅
m (1.7 kgf-m, 12.5 ft-lb)
⋅
m (0.5 kgf-m, 3.7 ft-lb)
⋅
m (1.9 kgf-m, 0.94 ft-lb)
FU-02125
FU-02126
FU-02124