Subaru Legacy 2005 Service Manual page 1574

MECHANICAL
14) Tighten the nuts which install the front cushion
rubber onto crossmember.
Tightening torque:
⋅
85 N m (8.7 kgf-m, 62.7 ft-lb)
NOTE:
Make sure the front cushion rubber mounting bolts
(A) and locator (B) are securely installed.
(B) (A)
15) Install the front exhaust pipe.
<Ref. to EX(H6DO)-5, INSTALLATION, Front Ex-
haust Pipe.>
NOTE:
• Be careful not to let the front exhaust pipe inter-
fere with water pipes and crossmember on engine
side.
• Be careful not to scratch the flange surface of
front exhaust pipe with stud bolt on engine.
16) Connect the ground cable.
17) Install the under cover.
18) Lower the vehicle.
19) Connect the following hoses.
(1) Fuel delivery hose and evaporation hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
(4) Pressure regulator vacuum hose
Engine Assembly
(A) (B)
ME-00494
ME-02027
ME(H6DO)-40
20) Connect the following connectors:
(1) Engine ground terminals
Tightening torque:
⋅
14 N m (1.4 kgf-m, 10.1 ft-lb)
(2) Engine harness connectors
(3) Generator connector and terminal
(4) A/C compressor connector
(5) Power steering switch connector
21) Install the A/C pressure hoses.
<Ref. to AC-39, INSTALLATION, Hose and Tube.>
22) Install the V-belts. <Ref. to ME(H6DO)-33, IN-
STALLATION, V-belt.>
23) Install the radiator to vehicle. <Ref. to
CO(H6DO)-17, INSTALLATION, Radiator.>
24) Install the air intake duct, air cleaner case and
air intake chamber. <Ref. to IN(H6DO)-8, INSTAL-
LATION, Air Intake Duct.> <Ref. to IN(H6DO)-6,
INSTALLATION, Air Cleaner Case.> <Ref. to
IN(H6DO)-7, INSTALLATION, Air Intake Cham-
ber.>
25) Install the battery in the vehicle and connect ca-
bles.
26) Fill engine coolant.
<Ref. to CO(H6DO)-11, FILLING OF ENGINE
COOLANT, REPLACEMENT, Engine Coolant.>
27) Check the ATF level and replenish it if neces-
sary.
<Ref. to 5AT-28, INSPECTION, Automatic Trans-
mission Fluid.>
28) Charge the A/C system with refrigerant. <Ref.
to AC-21, PROCEDURE, Refrigerant Charging
Procedure.>
29) Install the collector cover.
ME-00476
ME-02382