Subaru Legacy 2005 Service Manual page 1588

MECHANICAL
18.Rear Chain Cover
A: REMOVAL
1) Remove the crank pulley. <Ref. to ME(H6DO)-
44, REMOVAL, Crank Pulley.>
2) Remove the front chain cover. <Ref. to
ME(H6DO)-45, REMOVAL, Front Chain Cover.>
3) Remove the timing chain. <Ref. to ME(H6DO)-
47, REMOVAL, Timing Chain Assembly.>
4) Remove the cam sprocket. <Ref. to ME(H6DO)-
52, REMOVAL, Cam Sprocket.>
5) Remove the crank sprocket.
6) Remove the oil pump. <Ref. to LU(H6DO)-8,
REMOVAL, Oil Pump.>
7) Remove the water pump. <Ref. to CO(H6DO)-
13, REMOVAL, Water Pump.>
8) Remove the rear chain cover.
NOTE:
Installation bolt has seven different sizes. To pre-
vent the confusion in installation, keep these bolts
on container individually.
(A) (B)
(G)
(A) M6 × 14
(B) M6 × 18 (Silver)
(C) M6 × 30
(D) M6 × 18
(E) M8 × 40
(F) M8 × 30
(G) M6 × 22
Rear Chain Cover
(C)
(D)
(E)
(F)
ME-02048
ME(H6DO)-54
B: INSTALLATION
1) Remove the used liquid gasket from mating sur-
face, and degrease it.
2) Apply liquid gasket to the mating surface of rear
chain cover.
Liquid gasket:
THREE BOND 1280B (Part No. K0877YA018)
Applying liquid gasket diameter:
±
(A) 1.0 0.5 mm (0.039
±
(B) 3.0 1.0 mm (0.118
(A)
(B)
3) Install the O-ring.
NOTE:
• Do not reuse the O-ring.
• Do not install the O-ring in wrong place.
(A)
(D)
(A) 14.2 × 1.9
(B) 19.2 × 2.4
(C) 25 × 2
(D) 31.2 × 1.9
±
0.020 in)
±
0.039 in)
ME-02049
(A)
(C)
(B)
ME-02457