Subaru Legacy 2005 Service Manual page 1670

LUBRICATION
(1) Oil pan lower
(2) Magnet
(3) Drain plug
(4) Gasket
(5) Oil cooler pipe
(6) Hose
(7) Clamp
(8) O-ring
(9) Oil cooler
(10) Oil cooler connector
(11) Oil filter
(12) Oil pump cover
(13) Inner rotor
C: CAUTION
• Wear work clothing, including a cap, protective
goggles and protective shoes during operation.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
D: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
ST-499977100
ST-498547000
General Description
(14) Outer rotor
(15) Crank sprocket
(16) Oil pan upper
(17) Plug
(18) Plug
(19) Plug
(20) Oil pressure switch
(21) Plug
(22) Oil strainer
(23) Plug
(24) Relief valve spring
(25) Relief valve
TOOL NUMBER DESCRIPTION
499977100 CRANK PULLEY
WRENCH
498547000 OIL FILTER
WRENCH
LU(H6DO)-4
Tightening torque: N
T1: 6.4 (0.65, 4.7)
T2: <Ref. to LU(H6DO)-8,
INSTALLATION, Oil Pump.>
T3: 16 (1.6, 12)
T4: 18 (1.8, 13)
T5: 23 (2.3, 17)
T6: 25 (2.5, 18.4)
T7: 37 (3.8, 27)
T8: 44 (4.5, 32.5)
T9: 54 (5.5, 40)
T10: 90 (9.2, 66)
• Be careful not to burn yourself, because each
part on the vehicle is hot after running.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Before disconnecting connectors of sensors or
units, be sure to disconnect the ground cable from
battery.
Used for stopping rotation of crank pulley when
removing and tightening crank pulley bolt.
Used for removing and installing oil filter.
⋅
m (kgf-m, ft-lb)
REMARKS