Table of Contents
Advertisement
4) Tighten the bolts which hold upper side of trans-
mission to engine.
NOTE:
Tighten the bolt (A) as shown in the figure together
with starter. (MT model)
Tightening torque:
⋅
50 N
m (5.1 kgf-m, 36.9 ft-lb)
(A)
5) Remove the lifting device and wire ropes.
6) Remove the garage jack.
7) Install the pitching stopper.
Tightening torque:
⋅
T1: 50 N
m (5.1 kgf-m, 36.9 ft-lb)
⋅
T2: 58 N
m (5.9 kgf-m, 42.8 ft-lb)
T2
8) Remove the ST from converter case. (AT model)
NOTE:
Be careful not to drop the ST into the converter
case when removing the ST.
ST 498277200
STOPPER SET
9) Install the starter. <Ref. to SC(H4SO 2.0)-6, IN-
STALLATION, Starter.>
10) Install the torque converter clutch to drive plate.
(AT model)
(1) Tighten the bolts which hold torque convert-
er clutch to drive plate.
Engine Assembly
(2) Tighten other bolts while rotating the engine
using a socket wrench.
Tightening torque:
25 N
ME-02627
(3) Install the service hole plug (A) to prevent
foreign matters from being mixed.
11) Install the power steering pump. <Ref. to PS-
83, INSTALLATION, Oil Pump.>
12) Lift-up the vehicle.
13) Tighten the bolts and nuts which hold lower
side of the transmission to engine.
T1
Tightening torque:
50 N
ME-02447
ME(H6DO)-39
⋅
m (2.5 kgf-m, 18.4 ft-lb)
(A)
⋅
m (5.1 kgf-m, 36.9 ft-lb)
MECHANICAL
ME-02445
ME-00484
Advertisement
Chapters
Table of Contents
