Resetting The Switch - Avaya 8800 Installation Manual

Procedure steps
1. Verify that the AC power cords connect to AC power outlets.
2. On each power supply, turn the power switch to the on position.
3. Verify the power LED on each power supply lights green.
4. Verify the power supply status LEDs and the fan LED on the 8692 SF/CPU or 8895
5. Verify air flows from the cooling fans out through the vents of the chassis.
6. If the power supply LED remains off or if you cannot feel air flow from the chassis
7. Wait 1 minute.
8. On each power supply, turn the power switch to the on position.

Resetting the switch

Reset the switch to reboot the switch hardware without cycling power.
Procedure steps
On the 8692 SF/CPU or the 8895 SF/CPU, press Reset.
Figure 38: Reset button
Installation — Chassis
If your chassis contains two or three power supplies, turn on the power supplies
simultaneously. If you wait longer to turn on the second power supply, one of the
power supplies can shut off within 7 seconds. To correct this condition, turn off the
power supplies for a short period of time, and then turn on the power supplies again
simultaneously.
Do not operate the 8010co chassis with only one power supply.
SF/CPU modules light green.
The fan tray red fail LED can light briefly while the fans power to operational
speed.
vents, on each power supply, turn the power switch to the off position.
If the problem persists, contact the Avaya Technical Solutions Center.
on page 72 shows the location of the Reset button.
Resetting the switch
November 2012 71