Juniper ACX1000 Configuration Manual page 355

Results
CLI Quick
Configuration
Step-by-Step
Procedure
Copyright © 2017, Juniper Networks, Inc.
user@host# set convert-clock-class-to-quality-level
Configure hybrid mode on the slave.
2.
[edit protocols ptp slave]
user@host# edit hybrid
Configure the Synchronous Ethernet mapping option, IP address of the master clock
3.
as 2.2.2.2, and the interface ge-1/2/3.0 for hybrid mode on the slave.
[edit protocols ptp slave]
user@host# set interface ge-1/2/3.0 unicast-mode clock-source 2.2.2.2
Display the results of the configuration of hybrid mode with the mapping of the PTP clock
class to the ESMC quality level:
[edit protocols ptp slave]
user@host# show
convert-clock-class-to-quality-level
interface ge-1/2/3.0 unicast-mode clock-source 2.2.2.2
hybrid
Hybrid Mode with a User-Defined Mapping of the PTP Clock Class to the ESMC
Quality Level
To quickly configure hybrid mode on the interface ge-1/2/3.0, copy the following
commands, paste them in a text file, remove any line breaks, and then copy and paste
the commands into the CLI.
[edit]
set protocols ptp slave hybrid
set protocols ptp slave hybrid
set protocols ptp slave interface unicast-mode ge-1/2/3.0 clock-source 2.2.2.2
set protocols ptp slave clock-class-to-quality-level-mapping quality-level prc clock-class
80
To configure hybrid mode with a user-defined mapping of the PTP clock class to the
ESMC quality level on an ACX Series router, perform the following steps:
Configure the quality-level
1.
statement on the slave at the
configure the
clock-class
override the mapping of the ESMC quality level to the clock class.
[edit protocols ptp slave]
user@host# set clock-class-to-quality-level-mapping quality-level prc clock-class
80
Configure hybrid mode on the slave.
2.
Chapter 9: Configuring Timing and Synchronization
option for the clock-class-to-quality-level-mapping
[edit protocols ptp slave]
option for the set quality level if you want to manually
hierarchy level and then
297