Configuring Layer 2 Control Protocol - Juniper ACX1000 Configuration Manual

CHAPTER 12

Configuring Layer 2 Control Protocol

Copyright © 2017, Juniper Networks, Inc.
Layer 2 Control Protocol on ACX Series Routers on page 404
Bridge Priority for Election of Root Bridge and Designated Bridge on page 406
Maximum Age for Awaiting Arrival of Hello BPDUs on page 406
Hello Time for Root Bridge to Transmit Hello BPDUs on page 407
Forward Delay Before Ports Transition to Forwarding State on page 407
Spanning-Tree Instance Interface on page 407
Spanning-Tree Instance Interface Priority on page 408
Spanning-Tree Instance Interface Cost on page 408
Spanning-Tree Instance Interface Point-to-Point Link Mode on page 409
Configuring a Spanning-Tree Instance Interface as an Edge Port for Faster
Convergence on page 409
Spanning-Tree Protocol Trace Options on page 410
Configuring Rapid Spanning-Tree Protocol on page 411
Configuring Multiple Spanning-Tree Protocol on page 413
Configuring MST Instances on a Physical Interface on page 415
Disabling MSTP on page 417
Configuring VLAN Spanning-Tree Protocol on page 417
RSTP or VSTP Forced to Run as IEEE 802.1D STP on page 420
Reverting RSTP or VSTP from Forced IEEE 802.1D STP on page 420
Tracing Spanning-Tree Operations on page 421
Understanding BPDU Protection for Spanning-Tree Instance Interfaces on page 423
Configuring BPDU Protection for Spanning-Tree Instance Interfaces on page 424
Configuring BPDU Protection on All Edge Ports on page 425
Understanding Loop Protection for Spanning-Tree Instance Interfaces on page 426
Loop Protection for a Spanning-Tree Instance Interface on page 427
Configuring Loop Protection for a Spanning-Tree Instance Interface on page 428
Example: Enabling Loop Protection for Spanning-Tree Protocols on page 429
403