Juniper ACX1000 Configuration Manual page 344

ACX Series Universal Access Router Configuration Guide
Verifying the PTP over Ethernet Multicast Dynamic, Master, and Slave Settings
Purpose
Action
Meaning
286
unicast-mode {
transport ipv4;
clock-source 110.1.1.250 local-ip-address 110.1.1.2;
}
}
}
master {
interface ge-0/1/4.0 {
multicast-mode {
transport ieee-802.3;
}
}
}
stateful {
interface ge-0/2/1.0 {
multicast-mode {
transport ieee-802.3 link-local;
}
}
}
After you have configured the device, enter the
Confirm that the configuration is working properly.
Verifying the PTP Clock Details on page 286
Verifying the Lock Status of the Slave on page 287
Verifying the PTP Options on the Slave on page 287
Verifying the PTP Options and the Current Status of the Master on page 287
Verifying the Number and Status of the PTP Ports on page 287
Verifying PTP Statistics on page 288
Verifying the PTP Clock Details
Verify that the PTP clock is working as expected.
In operational mode, enter the
globally configured clock details.
The output displays the clock details, such as the encapsulation method used for
transmission of PTP traffic and the number of configured stateful or dynamic ports.
Although a dynamic port functions as either a slave or a master port, the value displayed
in the field denotes the dynamic ports that you explicitly configured. The
Stateful Ports
number of dynamic ports is not computed and displayed in the fields that display the
explicitly configured master and slave ports. For more information about the
operational command, see
ptp clock
command in configuration mode.
commit
command to display comprehensive,
run show ptp clock
show ptp clock in the
Copyright © 2017, Juniper Networks, Inc.
run show
.
CLI Explorer