Configuring Transparent Clock Mode For Precision Time Protocol - Juniper ACX1000 Configuration Manual

Related
Documentation

Configuring Transparent Clock Mode for Precision Time Protocol

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
NOTE: ACX Series routers do not support transparent clock over MPLS
switched path.
NOTE: You might notice higher latency when you use copper SFP ports
instead of fiber SFP ports. In this case, you must compensate the latency
introduced by the copper SFP ports for the accurate CF (correction factor)
measurement.
Configuring Transparent Clock Mode for Precision Time Protocol on page 269
e2e-transparent on page 1505
In a distributed network, you can configure transparent clock for Precision Time Protocol
(PTP) for synchronizing the timing across the network. Junos OS supports the
e2e-transparent CLI statement at the [
transparent clock for Precision Time Protocol (PTP).
NOTE: Starting in Junos OS Release 17.2 onwards, to configure PTP
transparent clock, include the
] hierarchy level. The
protocols ptp
transparent clock at the [
in Junos OS Release 12.3X54.
To configure the transparent clock mode for Precision Time Protocol (PTP):
In configuration mode, go to the
1.
[edit]
user@host# edit protocols ptp
Specify transparent clock mode:
2.
[edit protocols ptp]
user@host# set e2e-transparent
Understanding Transparent Clocks in Precision Time Protocol on page 267
e2e-transparent on page 1505
show ptp global-information
Chapter 9: Configuring Timing and Synchronization
edit protocols ptp ] hierarchy level to configure
e2e-transparent CLI command at the [
transparent-clock
] hierarchy level is supported only
edit protocols ptp
[edit protocols ptp] hierarchy level.
edit
CLI command to configure
269