Step 5: Connect Power To The Acx Series Router; Connect Power To An Ac-Powered Acx500 Outdoor Router - Juniper ACX500 Quick Start Manual

Step 5: Connect Power to the ACX Series Router

IN THIS SECTION

Connect Power to an AC-Powered ACX500 Outdoor Router | 16

Connect Power to a DC-Powered ACX500 Outdoor Router | 18
Depending on your configuration, your router uses either AC or DC power supplies. Perform the appropriate
procedures for each power supply in your router.
Power cords for the ACX500 outdoor routers are not shipped with the router. They must be purchased
separately. These power cords are specifically designed to be used only with the specified ACX500 outdoor
routers.
NOTE:
Before making the AC or the DC power connection to the router, ensure that you disconnect
power at the circuit breaker of the power distribution unit (PDU), or the AC or the DC power
connection box. Only when the connection is properly completed, switch on the breaker.
To meet IEC/EN 60950-22 requirements, ensure additional protection is provided external to
this equipment to reduce transient surge from OVC IV to OVC II at the input of this unit. The
over voltage and fault current protection component used to achieve this protection must comply
with IEC 61643.
To meet CSA/CAN 22.2, UL 60950-22 requirements, use an alternative component to provide
additional protection. These component must comply to ANSI/IEEE C62.11, CSA certification
notice no.516, CSA 22.2 No.1, or UL 1449.
Connect Power to an AC-Powered ACX500 Outdoor Router
To connect power to the AC-powered router, you need the following tools:
AC power cord for the ACX500 outdoor router (not provided, must be purchased separately)
ESD grounding wrist strap
16