Power Steering
Steering Wheel Installation
1. Before installing the steering wheel, make sure the
3,
front wheels are aligned straight ahead, then center
the cable reel (A). Do this by first rotating the cable
reel clockwise until it stops. Then rotate it
4
counterclockwise about 2 and half turns.
The arrow mark (B) on the cable reel label point
should point straight up.
5
6.
2. Position the two tabs (A) of the turn signal cancelling
sleeve (B) as shown, and install the steering wheel
on to the steering column shaft, making sure the
steering wheel hub (C) engages the pins (D) of the
cable reel and tabs of the canceling sleeve. Do not
tap on the steering wheel or steering column shaft
when installing the steering wheel.
D
Install the steering wheel bolt and tighten it to
39 N-m (4.0 kgfm, 29 Ibf-ft).
Connect the radio remote switches connector and
cruise control switches connector if equipped.
Install the driver's airbag, and confirm that the
system is operating properly (see page 23-278).
Check the horn, radio remote switches, cruise
control set/resume switch and turn signal
cancelling for proper operation.
17-24