Dhcp Server Commands; Address (Dhcp Host) - Cisco 300 Series Cli Manual

DHCP Server Commands

OL-32830-01 Command Line Interface Reference Guide
12.0
12.1

address (DHCP Host)

To manually bind an IP address to a DHCP client, use the address command in
DHCP Pool Host Configuration mode. To remove the IP address binding to the
client, use the no form of this command.
Syntax
ip-address
address {
mac-address
hardware-address
no address
Parameters
•
address
—Specifies the client IP address.
•
mask
—Specifies the client network mask.
•
prefix-length
—Specifies the number of bits that comprise the address
prefix. The prefix is an alternative way of specifying the client network
mask. The prefix length must be preceded by a forward slash (/).
•
unique-identifier
hexadecimal notation. Each byte in a hexadecimal character string is two
hexadecimal digits. Bytes are separated by a period or colon. For example,
01b7.0813.8811.66.
•
mac-address
—Specifies the client MAC address.
Default Configuration
No address are bound.
Command Mode
DHCP Pool Host Configuration mode
mask prefix-length
| } {client-identifier
}
—Specifies the distinct client identification in dotted
12
unique-identifier
|
279