Guidelines For Changing The Node Description And Ip Address Of An Ioa Cluster; Cluster; Shut Down The Ioa Cluster On Switch1; Shut Down The Ioa Cluster On Switch2 - Cisco MDS 9000 series Configuration Manual

Additional Configurations
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Guidelines for Changing the Node Description and IP Address of an IOA Cluster

Follow these steps to change the node description and IP address of an IOA node in the existing IOA

cluster.

Step 1 Shut down the IOA cluster on the switch1.
Step 2 Shut down the IOA cluster on the switch2.
Step 3 Remove the IOA cluster on the switch2.
Remove the node of switch2 in the switch1.
Step 4
Do one of the following based on what you want to perfom on the switch:
Step 5
•
•
•
Change node description using "node id id, node-description ip-address ip address" command on
Step 6
switch1.
Shut down the IOA cluster on the switch1.
Step 7
Add switch2 node with new description and the IP address .
Step 8
Add IOA interfaces on switch2.
Step 9
Configuration Example for Changing the Node Description and Node IP Address
of an IOA Cluster
This example shows the following configuration procedures used to change the description and IP
address:
•
•
•
•
•
•
•
•
•
•
Cisco MDS 9000 Family I/O Accelerator Configuration Guide
4-18
Change the management interface IP Address.
Change the IP address and the switch name.
Enable or disable DNS configuration.
This step may vary depending on when the node description (DNS name) needs to be changed or
node description and node IP address to be changed.
Shut Down the IOA Cluster on switch1, page 4-19
Shut Down the IOA Cluster on switch2, page 4-19
Remove the IOA Cluster on switch2, page 4-19
Remove the Node of switch2 in switch1, page 4-19
Change the Management Interface IP Address on Switches, page 4-20
Change the Node Description and IP Address on switch1, page 4-20
No Shut Down IOA Cluster on switch1, page 4-20
Add switch2 Node with New Description and the IP Address, page 4-20
Add IOA Interfaces on switch2, page 4-20
Verify the Node Description and IP Address and Flows, page 4-20
Chapter 4 Configuring IOA Using the CLI
OL-20708-01, Cisco MDS NX-OS Release 5.0(1a)