Ip Igmp Snooping Vlan Mrouter - Cisco ME 3800X Command Reference Manual

Hide thumbs Also See for ME 3800X:
Table of Contents

Advertisement

ip igmp snooping vlan mrouter

ip igmp snooping vlan mrouter
To add a multicast router port or to configure the multicast learning method, use the ip igmp snooping
vlan vlan-id mrouter command in global configuration mode. To return to the default settings, use the
no form of this command.
Though visible in the command-line help strings, the cgmp keyword is not supported.
Note
Syntax Description
vlan-id
interface interface-id
learn pim-dvmrp
Defaults
By default, there are no multicast router ports.
The default learning method is pim-dvmrp—to snoop IGMP queries and PIM-DVMRP packets.
Command Modes
Global configuration
Command History
Release
12.2(52)EY
Usage Guidelines
VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP
snooping.
The configuration is saved in NVRAM.
You can verify your settings by entering the show ip igmp snooping privileged EXEC command.
Examples
This example shows how to configure a port as a multicast router port:
Switch(config)# ip igmp snooping vlan 1 mrouter interface gigabitethernet0/2
Cisco ME 3800X and ME 3600X Switch Command Reference
2-114
ip igmp snooping vlan vlan-id mrouter {interface interface-id | learn pim-dvmrp}
no ip igmp snooping vlan vlan-id mrouter {interface interface-id | learn pim-dvmrp}
Enables IGMP snooping, and add the port in the specified VLAN as the
multicast router port. The range is 1 to 1001 and 1006 to 4094.
Specifies the next-hop interface to the multicast router. Valid interfaces are
physical interfaces and port channels. The port-channel range is 1 to 48.
Specifies the multicast router learning method. The only learning method
supported on the Cisco ME switch is pim-dvmrp, which sets the switch to
learn multicast router ports by snooping on IGMP queries and
Protocol-Independent Multicast-Distance Vector Multicast Routing Protocol
(PIM-DVMRP) packets.
Modification
This command was introduced.
Chapter 2
Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
OL-28238-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Me 3600x

Table of Contents