Front Panel Description - Cisco Catalyst 6500 Series Installation Note

Front Panel Description

This section describes the physical attributes of the Content Switching Module.
Figure 1
Figure 1
Status
LED
The RJ-45 connector is covered by a removable plate.
Note
Status LED
When the CSM powers up, it initializes various hardware components and communicates with the
supervisor engine. The Status LED indicates the supervisor engine operations and the initialization
results. During the normal initialization sequence, the status LED changes from off to red, orange, and
green.
Note For more information on the supervisor engine LEDs, refer to the Catalyst 6500 Series Switch Module
Installation Guide.
Table 1
Table 1
Color
Off
Red
78-15751-01
shows the CSM front panel.
Content Switching Module Front Panel
RJ-45 (Test)
connector
describes the Status LED operation.
Content Switching Module Status LED
Description
The module is waiting for the supervisor engine to provide power.
•
The module is not online.
•
The module is not receiving power, which could be caused by the following:
•
Power is not available to the CSM.
–
Module temperature is over the limit
–
• The module is released from reset by the supervisor engine and is booting.
• If the boot code fails to run, the LED stays red after power up.
Catalyst 6500 Series Switch Content Switching Module Installation Note
Front Panel Description
CSG
1
.
5