Ir/Wired Remote Keypad - Christie Mirage 304K Installation And Setup Manual

ID Component
K Adjustable feet
L Service compartment
M Tool box
N Rear IR
O LED status indicator
P Shutter LED status indicator
Q Lamp door
R AC lock
S AC Input 2: limited power
T AC Input 1: full power
U Power cord: limited power
V Power cord: full power

IR/wired remote keypad

The IR/wired remote keypad controls the projector by way of either wireless communications from a
battery-powered infrared (IR) transmitter or a wired interface.
To use the IR remote, direct the keypad toward the projector's front or rear IR sensor and press a
function key. One of the two IR sensors on the projector detect the signal and relay the commands for
internal processing. The remote also offers a connector for wired connections to the projector.
Mirage 304K (Bm.1) Installation and Setup Guide
020-102013-12 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
Raise or lower these feet when positioning the projector to make sure it
is level on all sides so the displayed image appears rectangular without
any keystone.
Access to fold mirror, optical zoom/focus, and DMD convergence
adjustments.
Provides tools for Christie qualified technicians.
Receives transmissions from the IR remote.
Indicates lamp and power status.
Indicates shutter status.
Access to lamp compartment.
Locks Input 1 power cord.
Use this IEC 320-C14 inlet to connect to an appropriately rated power
cord (component R) provided for your region. For use in limited power
mode.
Use this IEC 309 inlet to connect to an appropriately rated power cord
(component S) provided for your region. For use in full power mode.
Connects the provided power cord appropriately rated for your region to
AC Input 2 for limited power mode.
Connects the provided power cord appropriately rated for your region to
AC Input 1 for full power mode.
Installation and setup
17