Built-In Keypad; Wired Remote - Christie Mirage M Series User Manual

• ASCII Messaging—Connect a serial link between your controller and the RS232 or RS422
port (recommended), or open an Ethernet socket (such as Telnet) between your controller and
the valid projector address. Valid ASCII codes and messages are documented in the Christie
Serial Communications document available at the Christie website.
• Web Interface—Connect the PC to the projector's Ethernet port. In the web browser (such as
Internet Explorer), enter the IP address of the projector you want to control. This prompts a
login screen. The default login ids are: admin, service, and guest.
Up to a maximum of three users can connect at any given time. Two users can use the same
account to log in. Each user sees a different set of tabs. The default passwords can be edited by
an administrator or a service user in the Admin tab. Guest users do not see this tab. Basic
operations of the projector can be controlled from this interface and the Virtual on-screen
display can be accessed from here.

Built-in keypad

The built-in keypad has a LCD status display window which displays all states of the keypad
controls. The LCD displays status information when the projector is powering up Warm up: Lamp is
warming up and when the projector is cooling down Cool down: Lamp is cooling down. The display
shows the state of the keys, menu structure, and menu items.

Wired remote

You can convert the remote keypad into a wired remote keypad using any standard 3-pin XLR cable
(male to female). Connect one end into the remote and the other to the XLR connector on the Wired
Keypad input panel. Christie recommends the wired remote when:
• The built-in keypad is inaccessible
• The lighting conditions are unsuitable for proper IR transmission
Mirage M Series User Manual
020-101942-02 Rev. 1 (10-2018)
http://www.pureglare.com.au
56