Using The Ir Remote; Wired Remote - Christie Matrix StIM-WQ User Manual

Using the IR Remote

Laser radiation is emitted from the laser diode in the remote. Do not look directly into the
laser beam. Failure to comply could result in minor or moderate injury.
The IR remote is included with the User Kit (P/N: 130-103105-xx), which is shipped
separately.
The standard IR remote can be used as a wired or wireless control. Under optimal conditions, the
wireless keypad can communicate with a projector over a 30 foot (10 m) distance. In wireless mode,
the standard IR remote communicates with a battery-powered infrared (IR) transmitter.
A laser pointer is built into the standard IR remote.
• Press keys one-at-a-time; there are no simultaneous key combinations required.
• Arrow keys are held down for continuous adjustment/movement in the related key direction.
• In serial networks, pause briefly between adjustments to make sure that distant displays can
keep pace with the commands. If you press a key while the display is still responding to the
previous action, such as during a power-up, the second key press may not take effect.
• See IR Remote Commands

Wired Remote

The wired remote is recommended when the lighting conditions are unsuitable for proper IR
transmission. You can convert the standard IR remote into a wired remote using an optional cable.
Connect one end into the standard IR remote, and the other into the designated port on the input panel.
Batteries are only needed for the wired remote if the laser pointer is required.
To use the wired remote, make sure it is enabled on the display that it is connected to. To check
wired remote status select Configuration > Communications > Wired Keypad Enabled.
To use the wired remote to control multiple projectors in an ArrayLOC network, make sure that wired
remote support is enabled on the controlling display, and that key synchronization is enabled on the
controlling display and on all the receiving projectors. To synchronize go to ArrayLOC > ArrayLOC
Configuration > Synchronize Keys, Test Pattern, Color Enable.
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
on page 38 for a description of the keys.
37