Lenses; Inputs; Control; Wired Remote (Converted From Ir Remote) - Christie Roadie HD+35K Setup Manual

Section 5: Specifications
5.2

Lenses

IMPORTANT!
5.3

Inputs

Total number of standard inputs
Not applicable with all models.
NOTE:
• Analog: RGB / YPbPr (5 BNCs at INPUT 1)
• Analog: Video (INPUTS 3 and 4)
• Analog: Sync (Interlaced or Progressive Scan Format)
• DVI-I (INPUT 2)
• Dual SD/HD-SDI (INPUT 5 or 6, Standard with Projector)
5.4

Control

5.4.1 Wired Remote (Converted from IR Remote)

2 inputs on projection head
Input levels
Voltage output
Current output
Cable length

5.4.2 IR Remote

Number of IR sensors on projector
Wavelength of peak sensitivity
Modulation (carrier) frequency
Encoding method
Range
(using optional "lite" remote)
Assumes no fluorescent lighting interference.
If range appears limited, shield the IR sensor, turn off lights, or change your fluorescent ballast.
5-2
For proper placement in any installation, use the lens and screen size to calculate the
precise throw distance using the tables provided in the Dealer Section of the Christie
Website, PN 020-100395-xx. In addition, please keep in mind that due to lens
manufacturing tolerances for lens focal length, actual throw distance can vary ±5% or
more between lenses described as having the same throw ratio.
6
• 3-pin XLR connector (rear)
• 3.5mm phono jack (side)
• High = 2.2 V – 5.6 V (or open)
• Low = -0.6V – 0.9V @ 1mA
+5VDC ±5%
100 mA nominal, 250 mA max.
25 ft.
2 (front and rear)
1000 nm (approx.)
38 kHz (nominal)
bi-phase
100 ft.
50 ft. min.
(including Dual SD/HD-SDI).
Roadie HD+35K Setup Guide
020-100394-02 Rev. 1 (01-2010)