P/S Pump And A/C Compressor; Adjustment For M16 Engine Model; P/S Pump And A/C Compressor (If Equipped) Drive Belt Removal And Installation For M16 Engine Model - Suzuki GRAND VITARA Owner's Manual

P/S Pump and A/C Compressor (If Equipped)
Drive Belt Inspection and Adjustment for M16
Engine Model
Inspection
• Check that belt is free from any damage and properly
fitted in pulley groove.
• Check belt tension by measuring how much it deflects
when pushed at intermediate point between pulleys
with about 10 kg (22 lb) force.
Deflection of P/S belt with A/C
(a): 9 – 10 mm (0.35 – 0.39 in.)
Deflection of P/S belt without A/C
(b): 4 – 9 mm (0.16 – 0.35 in.)
[A]
4
6
3
[B]
4
6
3
1. P/S pump pulley
2. A/C compressor pulley (if equipped)
3. Crankshaft pulley
4. Tension pulley
S5JB0A6306004
1
5
"a"
2
1
5
"b"
I5JB0A630013-01
5. Tension pulley bolt
6. Tension pulley nut
[A]: with A/C
[B]: without A/C
Power Assisted Steering System:
Adjustment
1) To adjust P/S belt tension, loosen tension pulley bolt
(2) and nut (1) and turn tension pulley (3) using
hexagon wrench (4).
2) Adjust belt tension to specification, and then tighten
tension pulley bolt (2) and nut (1) to specified torque.
Tightening torque
P/S belt tension pulley bolt (a): 25 N·m (2.5 kgf-
m, 18.5 lb-ft)
P/S belt tension pulley nut (b): 25 N·m (2.5 kgf-
m, 18.5 lb-ft)
5
4
6
1, (b)
5. Loose
6. Tight
P/S Pump and A/C Compressor (If Equipped)
Drive Belt Inspection and Adjustment for J20
Engine Model
Refer to "Water Pump and Generator Drive Belt On-
Vehicle Inspection (For J20 Engine): in Section 1J".
P/S Pump and A/C Compressor (If Equipped)
Drive Belt Removal and Installation for M16
Engine Model
Removal
1) Remove tension pulley bolt (1) and nut (2).
2) Remove tension pulley (3) and P/S pump drive belt
(4).
3
2
Installation
Reverse removal procedure noting the following
instruction.
Adjust belt tension referring to "P/S Pump and A/C
Compressor (If Equipped) Drive Belt Inspection and

Adjustment for M16 Engine Model: ".

6C-9
2, (a)
7
3
8
I5JB0A630014-01
7. P/S pump pulley
8. Crank shaft pulley
S5JB0A6306017
S5JB0A6306018
1
4
I5JB0A630015-01