Suzuki GRAND VITARA Owner's Manual page 820

4C-8 Rear Brakes:
4) Remove brake drum referring to "Rear Brake Drum
Removal and Installation: ".
5) Remove brake shoe referring to "Rear Brake Shoe
Removal and Installation: ".
6) Remove wheel cylinder referring to "Wheel Cylinder
Removal and Installation: ".
7) Remove parking brake cable (1) from brake back
plate by loosening parking cable cap nut (2).
2
1
8) Remove rear wheel hub housing bolts (1).
1
9) Remove rear wheel hub assembly and brake back
plate from knuckle.
Installation
1) Install brake back plate (1) and rear wheel hub
assembly (2) to knuckle, and tighten wheel hub
housing bolts to specified torque.
Tightening torque
Rear wheel hub housing bolt (a): 50 N·m (5.0
kgf-m, 36.5 lb-ft)
(a)
2) Tighten rear axle nut (1) temporarily by hand at this
step.
3) Install parking brake cable (1) to brake back plate
and tighten cable cap nut to specified torque.
Tightening torque
Parking cable cap nut (a): 11 N·m (1.1 kgf-m, 8.0
lb-ft)
I5JB0A430015-01
1
4) Install wheel cylinder and rear brake shoe referring
to step 1) to 7) of "Wheel Cylinder Removal and
Installation: ".
I5JB0A230061-01
5) Install brake drum and adjust brake referring to step
1) to 4) of "Rear Brake Drum Removal and
Installation: ".
6) Pull up parking brake lever fully and tighten rear axle
nut (1).
Tightening torque
Rear axle nut (a): 200 N·m (20.0 kgf-m, 145.0 lb-
ft)
7) Caulk rear axle nut (1).
1
2
I5JB0A430016-01
(a)
1
I5JB0A430017-01
1
I5JB0A430018-01
I5JB0A230065-01