Suzuki GRAND VITARA Owner's Manual page 1020

5B-15 Manual Transmission/Transaxle:
1
1
5) Disconnect clutch fluid joint from pipe of clutch
operating cylinder assembly referring to "Clutch
Operating Cylinder Assembly Removal and
Installation: in Section 5C".
6) Hoist vehicle.
7) Drain oil from transmission and transfer.
8) Remove propeller shafts referring to "Propeller Shaft
Removal and Installation: in Section 3D".
9) Remove exhaust No. 2 pipe.
10) Remove engine under cover.
11) Remove clutch housing lower plates (1).
12) Remove transmission fastening nut (2) and bolts (3).
1
1
3
1
2
I5JB0A520016-01
2
3
I5JB0A520028-01
13) Disconnect the following couplers and release their
harness from clamps.
• Back up light switch
• Transfer shift actuator (for J20 engine model)
• 4L/N switch (for J20 engine model)
• Center differential lock switch (for J20 engine
model)
14) Apply transmission jack (1) and remove engine rear
mounting member (2) taking off its bolts.
1
15) After removing mounting member, move rearward
transmission and transfer assemblies placed on jack
and then lower them.
16) Separate gear shift control lever rear case assembly
(2) and transfer assembly (3) from transmission
assembly (1).
1
2
I5JB0A520029-01
2
3
I5JB0A520030-02