Suzuki GRAND VITARA Owner's Manual page 859

Installation
1) Install hydraulic unit / control module assembly by reversing removal procedure.
Tightening torque
Brake pipe flare nut (a): 16 N·m (1.6 kgf-m, 11.5 lb-ft)
ABS hydraulic unit / control module assembly bolt (b): 9 N·m (0.9 kgf-m, 6.5 lb-ft)
ABS hydraulic unit / control module assembly bracket bolt (c): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
ABS hydraulic unit / control module assembly bracket nut (d): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
2) Connect harness clamp to bracket.
3) Install ECM referring to "Engine Control Module (ECM) Removal and Installation: in Section 1C".
4) Connect negative cable at battery.
5) Bleed air from brake system referring to "Air Bleeding of Brake System: in Section 4A".
6) Check each installed part for fluid leakage and perform "ABS Hydraulic Unit Operation Check: ".
NOTE
For new ABS hydraulic unit / control module assembly, if "ABS Hydraulic Unit Operation Check: " has
not been performed, ABS warning lamp may flash when ignition switch is turned ON position.
Accordingly preform "ABS Hydraulic Unit Operation Check: " to stop flashing of ABS warning lamp.
(a)
(b)
(d)
(a)
ABS:
(b)
(c)
I5JB0A450025-01
4E-33