A/C Compressor Control System Check; A/C Compressor Relay Circuit Check; A/C Compressor Relay Check - Suzuki GRAND VITARA JB416 Service Manual

1A-70 Engine General Information and Diagnosis:
Step
11

A/C compressor control system check

Is A/C compressor started when A/C and blower speed
selector switch are turned ON with engine running?

12 A/C compressor relay circuit check

1) Measure voltage between "E23-49" wire terminal of
ECM connector and vehicle body ground under following
conditions respectively.
Voltage between "E23-49" terminal of ECM
connector and ground
While engine running and A/C switch turned OFF: 10
– 14 V
While engine running, A/C and blower speed
selector switch turned ON: 0 – 1 V
Is check result satisfactory?

13 A/C compressor relay check

1) Check A/C compressor relay referring to "A/C
Compressor Relay Inspection: in Section 7B in related
manual".
Is it in good condition?
14 A/C compressor relay circuit check
1) Remove A/C compressor relay with ignition switch
turned OFF.
2) Turn ON ignition switch, measure voltage between "YEL/
GRN" wire terminal of A/C compressor relay connector
and vehicle body ground.
Is voltage 10 –14 V?
15 A/C compressor relay check
1) Check A/C compressor relay referring to "A/C
Compressor Relay Inspection: in Section 7B in related
manual".
Is it in good condition?
Action Yes
A/C system is in good
condition.
Go to Step 13.
A/C compressor drive
circuit malfunction.
Go to Step 15.
"PNK" wire is open
circuit. If OK, substitute
a known-good ECM and
recheck.
No
Go to Step 12.
Go to Step 14.
Replace A/C
compressor relay.
"YEL/GRN" wire is open
circuit.
Replace A/C
compressor relay.