Rear Suspension Frame, Bushing And Pad Check; Rear Wheel Hub Assembly And Rear Suspension Knuckle Components - Suzuki GRAND VITARA Owner's Manual

2C-24 Rear Suspension:
Assembly
1) Press-fit rear suspension frame bushing (2) by using
press (1) and special tool.
CAUTION
!
Be sure to use new bushing.
Special tool
(A): 09913–75510
1
(A)
2
2) Install rear suspension frame stopper (3) to rear
suspension frame bushing (1) and press-fit upper
mount stopper washer (2) by using press with
bearing installer.
CAUTION
!
Be sure to use new upper mount stopper
washer and rear suspension frame stopper.

Rear Wheel Hub Assembly and Rear Suspension Knuckle Components

1
1. Rear wheel hub assemble
2. Back plate
Rear Suspension Frame, Bushing and Pad
Check
Inspect for cracks, deformation or damage. If any faulty
condition is found, replace.
I5JB0A230085-01
2
3. Rear suspension knuckle
4. Rear wheel hub housing bolt
NOTE
Use bearing installer in dimensions of outer
diameter 43.0 to 49.0 mm (1.69 to 1.92 in.),
inner diameter 41.0 mm (1.61 in.) or more and
length 21.0 mm (0.82 in.) or more.
Clearance "a" between washer and bushing
"a": 1.5 mm (0.059 in.)
3
: 50 N⋅m (5.0 kgf-m, 36.5 lb-ft)
I5JB0A230080-01
S5JB0A2306017
I5JB0A230056-02
S5JB0A2306038
4
(a)
I5JB0A230057-01