Suzuki GRAND VITARA Owner's Manual page 1536

9E-7 Glass / Windows / Mirrors:
7) Using new brush, apply sufficient amount of primer
onto glass along glass edge.
NOTE
• Be sure to refer to maker's instruction for
proper handling and drying time.
• Do not apply primer on outside of ceramic
coated surface.
• Do not touch primer coated surface.
Width applied primer for windshield
"a": 15 mm (0.59 in.)
"b": 20 mm (0.79 in.)
1
"a"
"b"
2
1. Molding
2. 21.4 mm (0.84 in.)
8) Apply primer for molding along molding surface all
around.
9) Apply adhesive (1) referring to figure.
NOTE
• Press glass (2) against fittings surface of
body panel quickly after adhesive (1) is
applied.
• Use of rubber sucker grip is helpful to hold
and carry glass after adhesive (1) is
applied.
• Perform steps 8) to 9) within 10 min. to
ensure sufficient adhesion.
• Be sure to refer to adhesive maker's
instruction for proper handling and drying
time.
• Start from bottom side of glass (2).
• Be careful not to damage primer.
1
"a"
I5JB0A950005-01
10) Holding rubber sucker grips (1), place glass onto
Adhesive amount specifications and position for
windshield
Width "a": Approx. 7 mm (0.27 in.)
Height "b": Approx. 15 mm (0.59 in.)
Position "c": Approx. 4 mm (0.15 in.)
Position "d": Approx. 35 mm (1.38 in.) for bottom
section
3
1
3
2
"a"
"c"
2
1
"d"
3. Molding
body.
"b"
1
3
"b"
"a"
"c"
2 3
"b"
"a"
I5JB0A950006-02
I2RH01950050-01