Transfer Oil Seal Removal And Installation; Transfer Switch Removal And Installation; Installation - Suzuki GRAND VITARA Owner's Manual

Transfer Oil Seal Removal and Installation

Removal
1) Lift up vehicle and drain transfer oil.
2) Remove front propeller shaft and/or rear propeller
shaft referring to "Propeller Shaft Removal and
Installation: in Section 3D".
3) Remove front oil seal No.1 (1) and/or rear oil seal (2)
using flat end rod or the like.

Installation

1) Install new oil seal using special tool and plastic
hammer, and then apply grease to oil seal lip.
: Grease 99000–25010 (SUZUKI Super Grease
A)
Special tool
(A): 09913–70123
Transfer: Motor-Shift Type (Transfer with Shift Actuator) 3C-55
S5JB0A3316035
1
2
2) Install front propeller shaft and/or rear propeller shaft
referring to "Propeller Shaft Removal and
Installation: in Section 3D".
3) Fill transfer oil referring to "Transfer Oil Change:
Motor-Shift Type (Transfer with Shift Actuator)".

Transfer Switch Removal and Installation

I5JB0A331031-01
Removal
Remove HVAC control module referring to "HVAC
Control Module Removal and Installation: in Section
7A", and then remove transfer switch (1) from center
cluster (2).
Installation
Reverse removal procedure.
1
(A)
(A)
I5JB0A331032-01
S5JB0A3316036
2
I5JB0A331003-02