Suzuki GRAND VITARA Owner's Manual page 773

18) Clean mating surface of both center case and rear
case (1), apply sealant to rear case as shown in
figure by such amount that its section is 1.2 mm
(0.047 in.) in diameter, mate center case with rear
case and then tighten bolts (2) to specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Rear case bolt (a): 23 N·m (2.3 kgf-m, 17.0 lb-ft)
1
Transfer: Non-Shift Type (Transfer without Shift Actuator) 3C-85
19) Clean mating surface of both center case (1) and
"A"
1
2, (a)
I5JB0A331101-02
20) Install oil strainer (1) to rear case (2).
21) Install oil pump inner rotor (3), outer rotor (4) and
front case, apply sealant to center case as shown in
figure by such amount that its section is 1.2 mm
(0.047 in.) in diameter, mate front case (3) with
center case and then tighten bolts (2) to specified
torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Rear case bolt (a): 23 N·m (2.3 kgf-m, 17.0 lb-ft)
1
2, (a)
3
Tightening torque
Strainer bolt (a): 10 N·m (1.0 kgf-m, 7.5 lb-ft)
drive pin (5) to rear case.
2
5
1
"A"
2, (a)
I5JB0A331102-02
3
4
(a)
I5JB0A331103-01