Suzuki GRAND VITARA Owner's Manual page 997

13) After confirming that lugs of all brake plates and
brake discs are in grooves securely, hold retaining
ring (1) of planetary sun gear, install center support
assembly by aligning bolt holes (2) in center support
and transmission case.
NOTE
Unless retaining ring of planetary sun gear is
held, brake valve gets off center support and
that will make it impossible to align fluid
holes with bolt holes.
14) Tighten center support bolts by certain amount at a
time till specified tightening torque is obtained.
Tightening torque
Center support bolt: 26 N·m (2.6 kgf-m, 19.0 lb-
ft)
15) Install direct clutch assembly by aligning splines in
direct clutch cylinder with planetary sun gear.
NOTE
Ends of splines in direct clutch cylinder and
planetary sun gear should come almost in
match.
16) Apply grease to thrust bearing (1) and bearing races
1
2
I5JB0A510133-01
17) Install forward clutch assembly by putting all lugs of
IYSQ01510246-01
Automatic Transmission/Transaxle:
(2), and then install them to direct clutch.
1
direct clutch disc hub together and matching them
with groove cut in direct clutch input hub, and at the
same time aligning splines in forward clutch hub with
inner shaft.
NOTE
Use care not to let forward clutch rear No.1
race and thrust bearing installed to forward
clutch hub fall off.
5A-129
IYSQ01510247-01
2
I5JB0A510134-01
IYSQ01510249-01