Auto-On Headlight Sensor Inspection (If
Equipped)
1) Disconnect negative (–) cable at battery.
2) Remove auto-on headlight sensor (1) located on the
passenger side of the dashboard (2). Be careful not
to damage the sensor (1) and dashboard by using
rag (3).
3
3) Measure voltage between white wire terminal and
black wire terminal at the following condition.
If measured voltage is out of specification, replace
sensor.
Tightening Torque Specifications
Fastening part
Height sensor bolt
Height sensor nut
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fastener Information: in Section 0A".
S5JB0A9206031
2
1
I5JB0A920038-01
Specifications
Auto-on headlight sensor voltage specifications
Cover the sensor lens with hand: 0.4 V
Light the sensor lens with incandescent lamp
100 W: 3 – 4.5 V
Tightening torque
N⋅m
kgf-m
8
0.8
8
0.8
Lighting Systems:
I5JB0A920039-01
S5JB0A9207001
Note
lb-ft
6.0
6.0
9B-31