9G-2 Seats:
Front Seat Removal and Installation
Removal
1) Disable air bag system referring to "Disabling Air Bag System: in Section 8B".
2) Disconnect seat harness coupler, seat heater coupler and side air bag coupler, if equipped.
3) Remove 4 mounting bolts to remove seat assembly.
4) Disassemble and repair seat as necessary.
Installation
Reverse removal procedure to install front seat.
• Torque to specifications as shown in "Front Seat Components: ".
• Enable air bag system referring to "Enabling Air Bag System: in Section 8B".
Front Seat Heater Switch (Driver and Passenger
Side) Inspection (If Equipped)
1) Confirm that ignition switch is OFF position.
2) Detach gear shift panel from front center console
box.
3) Disconnect seat heater switch coupler.
4) Check for continuity between terminals at each
switch position as shown below. If check result is not
as specified, replace.
Front Seat Heater Wire Inspection (If Equipped)
1) Confirm that seat heater switch is OFF position.
S5JB0A9706005
2) Disconnect coupler of seat heater under the seat
cushion.
3) Measure resistance between terminals as shown
below. If resistance is out of specification, replace
faulty seat cushion and/or seat back including seat
heater.
Seat heater circuit resistance
Seat cushion side [A] (between terminal "B" and
"C", between terminal "A" and "C"): 4.7 – 5.7 Ω
(at 20 °C, 68 °F)
Seat back side [B] (between terminal "F" and
"D": 10.7 – 13.1 Ω (at 20 °C, 68 °F)
I5JA01970001-01
[A]
[B]
A
B
C
1
2
1
1. Heater wire
2. Thermostat
[A]: Seat cushion side
[B]: Seat back side
S5JB0A9706002
S5JB0A9706006
D E
F
I5JB0A970002-01