Dtc C1057: Power Source Circuit - Suzuki GRAND VITARA Owner's Manual

DTC C1057: Power Source Circuit

Wiring Diagram
2
[A]: ABS hydraulic unit / control module connector
(viewed from terminal side)
1. Battery
DTC Detecting Condition
The ABS control module monitors the power source voltage at terminal "E03-14". When the power source voltage
becomes extremely high or low while vehicle is running at more than 20 km/h (13 MPH), this DTC will be set. As soon
as the power source voltage becomes normal, the ABS warning lamp will be turned off and the ABS control module
will return to normal operation, but the set DTC will be remain.
DTC Troubleshooting
Step
1 Was "ABS Check" performed?
2 1) Disconnect ABS hydraulic unit / control module
connector with ignition switch turned OFF.
2) Check for proper connection to ABS hydraulic unit /
control module connector at terminals "E03-14" and
"E03-13".
3) If OK, then turn ignition switch to ON position and
measure voltage between terminals "E03-14" and "E03-
13".
±
Is voltage 9.7 0.3 V or more?
3 1) Turn ignition switch to OFF.
2) Check for proper connection to ABS hydraulic unit /
control module connector at terminals "E03-13" and
"E03-26".
3) If OK then turn ignition switch to ON and measure
resistance between each terminal of "E03-13" and "E03-
26" and vehicle body ground.
Is resistance less than 2
4 1) Measure voltage between positive battery terminal and
vehicle body ground with engine running.
±
Is voltage 9.7 0.3 V or more?
WHT/RED
E03-14
1
BLK E03-13
BLK E03-26
Action
Ω
?
12V
3
2. Main fuse box
3. ABS hydraulic unit / control module assembly
Go to Step 2.
Go to Step 5.
Go to Step 4.
Imperfect short between
"WHT/RED" wire circuit
and body ground.
[A]
E03
14 1
15 2
16 3
17 4
18 5
19 6
20 7
21 8
22 9
23 10
24 11
25 12
26 13
Yes
Go to "ABS Check: ".
Go to Step 3.
"BLK" wire circuit in
open or high resistance.
Check charging system
referring to "Generator
Test (Undercharged
Battery Check): in
Section 1J".
ABS: 4E-23
S5JB0A4504015
I5JB0A450016-02
No